Specifications
| Size | 28 x 21 cm |
|---|---|
| Weight | 4.4 kg / 9.7 lb |
| Dildo | Veined with balls, 360-degree bendable core |
| Rear channel | Tight, lined with raised particles |
| Insertable length | 15 cm |
| Material | Brown TPE, 100% waterproof |
| Use | Unisex; ride the dildo or enter the rear |
| In the box | Torso x 1 |
| Price | $136 |
| SKU | SDF-VS42-MALE |
Twenty-eight centimetres across, 4.4 kg in your hands, and a cock on the front you can bend in any direction. This is the larger of the two male butt casts in the store: an abdominal block with a tight rear entrance, moulded in brown TPE, waterproof throughout. Insertable length runs 15 cm. It is $136.29.
The dildo bends where you put it
The shaft is sculpted with balls and surface veining, and the core inside takes a full 360 degrees of twist. Angle it up for riding it face-on, sweep it back for a reverse position, or lay it flat while you use the rear entrance instead. Whatever shape you set, it holds until you change it, so you are not fighting the toy mid-session. Riding it works best with the block flat on a mattress and the shaft angled slightly toward you, which puts the pressure along the front wall rather than straight up; against a wall or the side of a bath, the same bend lets you take it standing. Fifteen centimetres go in, which is more than the 13.1 cm average erect measurement across the largest published survey of men.
The rear entrance, and what is inside it
Behind the cheeks the channel is poured narrow and lined with raised particles rather than smooth walls, so it drags across the head on every stroke instead of sliding. Spread the cheeks with both hands and the opening pulls apart the way the close frames show; let go and it closes around you again. Depth is 15 cm here as well, so the same length works whichever way round you use the piece, and the entrance grips tightest across the first few centimetres before the channel opens out. Water-based lube only, worked in before you start and topped up once mid-session, since the textured lining takes more of it than a plain sleeve does. Silicone and oil-based lubes both leave TPE sticky, and this material is chemically oil-friendly enough that it absorbs them rather than shedding them.
Four and a half kilos of resistance
Weight is what separates this from a hand-held sleeve. At 4.4 kg it stays put on a mattress under hard thrusting rather than sliding away, so both your hands are free. Put it on the edge of a bed and kneel behind it, drop it on the floor and stand over it, or set it on your lap facing away. A folded towel underneath kills the slap of skin against TPE if noise matters, and stops the block walking across a hard floor. The abdominal moulding on top gives a flat surface to push against, and the block is small enough to move one-handed between positions. Compared with the 3.9 kg cast one shelf over, this one is wider across the hips and heavier in the hand, which is the difference between a piece that shifts and one that stays.
Waterproof means the sink, not a wipe
The piece is 100 percent waterproof, which changes cleaning completely: carry it to the sink, run warm water and a mild soap straight through the channel, and rinse until it comes out clear. No propping, no drying stick, no careful work around electronics, because there are none. Stand it on a towel to drain, dry it fully, then dust it with cornstarch to stop the surface going tacky as the plasticiser rises. Ten minutes from finish to back in the drawer. Warm it first if you want it closer to skin: fifteen minutes with a heat pad over it, or fill a bowl with water at hand temperature and let it sit.
Both directions, one piece
Unisex is on the spec line and it is accurate: the dildo suits anyone who wants to ride, the rear entrance suits anyone who wants to penetrate, and a couple can use both in the same session. Between two people a condom over the shaft, changed each time, is the sensible route, because porous TPE holds onto whatever a rinse misses. The bend in the shaft is what makes the first half work at different heights and angles. Brown TPE throughout, no internal frame to rust, nothing to charge, and it ships in a plain box with the product name nowhere on the outside. Stored flat in a drawer with a light dusting of powder it stays as it arrived; keep it out of direct sun and away from radiators, since heat is the one thing that softens this material permanently.
